SYSTEM
AutoCreaser Pro 50
Pan head and Cross - head countersunk screws all have metric
Taptite threads and Pozi - drive recesses. Use No.2 point Pozidriv
or Supadriv drivers for all screws M4 & above, and No.1 point
drivers for M3 & below.
WARNING
WORK SHOULD BE CARRIED OUT BY A TRAINED AND COMPETENT
ENGINEER AND ALL SAFETY PROCEDURES SHOULD BE ADHERED
TO.
SWITCH OFF THE MAINS POWER BEFORE COMMENCING.
DO NOT USE PHILLIPS DRIVERS - THESE WILL DAMAGE THE
SCREWS & MAY SLIP, CAUSING DAMAGE OR INJURY
iii
iv
........ Identification
........ New Machine Preparation
For general identification of areas of the machines, the following
terms are used:-
Operator side (control consul facing)
Rear of machine (opposite to control consul)
Delivery end (to the left of the operator side)
Feeder end ( on your right)
Remove all packaging materials
All metal parts, including the folding rollers have a protective
coating and any excess should be removed.
Connect the power cable to the mains supply. The machine
requires 230V 50Hz 10 Amps or 220V 60Hz 15 Amps.
INTRODUCTION
Page 3
To Next Page
Loading...
