mori seiki CL-25 - Page 12

P-8
7)
Press the
[
TSUCLP
]
switch.
The
tailstock
is
unclamped
and the
joint
pin
extends
from
the
tailstock
so
that
it
is
connected
to
the saddle.
The
indicator
in
the
[
TSUCLP
]
switch is
lit.
If
the
indicator
in
the
[
TSUCLP
]
switch
is
not
lit
when the
[
TSUCLP
]
switch
is
pressed,
follow
the
procedure
below.
0
Press the
[
TSCLP
]
switch
to
clamp
the
tailstock
once.
@
Move
the
Z-axis
to
the
required position
and
press
the
[
TSUCLP
]
switch
again.
8)
After
making
sure
that
the
indicator
in
the
[
TSUCLP
]
switch has
been
lit,
move
the
tailstock
to
the
required
position
in
the
selected
operation
mode
(rapid
feed,
jog
feed,
handle
feed).
TSCLP TSUCLP
CD
TSTMOD
CD
AXIS
DIRECTION
HANDLE
X
F1F1FI
il
1
x
9)
Press the
[
TSCLP
]
switch.
The
tailstock is
clamped;
it
is
disconnected
from
the saddle.
The indicator
in
the
[
TSUCLP
]
switch
goes
off
and
the indicator
in
the
[
TSCLP
]
switch
is
TSCLP
TSUCLP
w
lit.
TSTMOD
When the tailstock is
clamped,
the connective
position
data
for
storing
is
automatically
updated.
10)
Press the
emergency
stop
button.
The
on-site
adjustment
mode
is cleared.