mori seiki MSG-500 User Manual

Applicable Model
NC LATHES
Before starting operation, maintenance, or programming, carefully read the
manuals supplied by Mori Seiki, the NC unit manufacturer, and equipment
manufacturers so that you fully understand the information they contain.
Keep the manuals carefully so that they will not be lost.
MM-CENL-H2EN
Applicable NC Unit
MSC-500 MSX-511 MSC-801
MSG-500 MSX-511III MSC-802
MSX-500 MSC-515 MSC-803
MSX-500III MSD-515 MSG-803
MSC-501 MSC-516 MSX-803
MSD-501 MSD-516 MSX-803III
MSD-501II MSD-516II MSG-805
MSG-501 MSC-518 MSX-805
MSX-501 MSD-518 MSX-805III
MSX-501III MSD-518II MSG-806
MSG-502 MSC-521 SEICOS Σ21L
MSX-502 MSC-700
MSX-502III MSC-701
MAINTENANCE MANUAL
The manuals for maintenance are comprised of the following
three manuals including this manual:
MAINTENANCE MANUAL, MAINTENANCE INFORMATION,
and INSTALLATION MANUAL.

mori seiki MSG-500 Specifications

General

Brand	mori seiki
Model	MSG-500
Category	Lathe
Language	English

Summary

Daily Inspection

The Importance of Daily Inspection

Explains the value of daily checks for machine accuracy and performance.

Notes on Inspections and Maintenance

Lubricating and Hydraulic Oil

Supplying Oil in Daily Maintenance

Procedures for supplying lubricating oil and coolant.

Inspection of the Chuck

Cleaning Machining Chamber/Setup Station

Precautions When Using Chip Conveyor

Opening/Closing the Electrical Cabinet Door

Safety precautions and procedures for accessing the electrical cabinet.

Preparation After Prolonged Idle Period

Regular Inspection

Importance of Inspections

Emphasizes the role of inspections for long-term machine accuracy.

Checks Prior to Maintenance

Safety checks and preparations required before starting maintenance work.

Precautions to be Observed by Technicians

Safety guidelines for technicians performing maintenance and repairs.

Cleaning Electrical Cabinet Air Filter

Cleaning the Coolant Tank

Steps for cleaning the coolant tank to maintain coolant supply and pump life.

Cleaning the Lubricating Oil Tank

Procedure for cleaning the lubricating oil tank and its components.

Cleaning the Suction Strainer in the Hydraulic Oil Tank

Cleaning Inside the Electrical Cabinet

Inspection and Replacement of Slide Seals

Timing Belt Replacement

Procedure and safety for replacing timing belts on gravity axes.

Changing Fluid of Hydraulic Tank

Steps for changing hydraulic fluid, ensuring cleanliness and proper level.

Changing the Battery

Procedures for replacing memory backup and position sensing batteries.

Adjusting the Setting Pressure

How to adjust hydraulic unit main pressure and air pressure.

How to Order Machine Parts

Ordering Procedure and Example