mori seiki MSG-502 - User Manual

Applicable Model
NC LATHES
Before starting operation, maintenance, or programming, carefully read the
manuals supplied by Mori Seiki, the NC unit manufacturer, and equipment
manufacturers so that you fully understand the information they contain.
Keep the manuals carefully so that they will not be lost.
MM-CENL-H2EN
Applicable NC Unit
MSC-500 MSX-511 MSC-801
MSG-500 MSX-511III MSC-802
MSX-500 MSC-515 MSC-803
MSX-500III MSD-515 MSG-803
MSC-501 MSC-516 MSX-803
MSD-501 MSD-516 MSX-803III
MSD-501II MSD-516II MSG-805
MSG-501 MSC-518 MSX-805
MSX-501 MSD-518 MSX-805III
MSX-501III MSD-518II MSG-806
MSG-502 MSC-521 SEICOS Σ21L
MSX-502 MSC-700
MSX-502III MSC-701
MAINTENANCE MANUAL
The manuals for maintenance are comprised of the following
three manuals including this manual:
MAINTENANCE MANUAL, MAINTENANCE INFORMATION,
and INSTALLATION MANUAL.

mori seiki MSG-502 Specifications

General

Brand	mori seiki
Model	MSG-502
Category	Lathe
Language	English

Summary

Signal Word Definition

Symbols Related to Warning

Explains DANGER, WARNING, CAUTION symbols for safety.

Foreword

Protection for Machine Operators

Outlines operator responsibilities for safety and proper operation.

Chapter A: Daily Inspection

2. Notes on Inspections and Maintenance

Key points for safe inspections and maintenance procedures.

4. Supplying Oil in Daily Maintenance

Procedures for replenishing oil and coolant correctly.

10. Opening;Closing the Electrical Cabinet Door

Safety procedures for accessing the electrical cabinet.

10.3 Main Power Switch

How to lock the main power switch during maintenance.

Chapter B: Regular Inspection

2. Checks Prior to Maintenance

Essential safety checks before performing maintenance tasks.

3. Precautions to be Observed by Technicians

Critical safety rules for maintenance personnel.

14. Changing the Battery

Guide to changing memory backup and position sensing batteries.

Chapter C: Outline of Systems

4. Chuck and Cylinder System

Details on the chuck and cylinder system and its components.

4.1 Safety Practices when Mounting;Removing a Chuck

Safety precautions for mounting/removing chucks.

How to Order Machine Parts

Information Required for Ordering Parts

Details needed to order replacement parts from the vendor.

Appendix: Conversion Table of Units

SI Unit System and Metric System Conversion

Table for converting between SI, metric, and imperial units.