MORLEY M35 - M35 Saw Specifications; M35 Air-Cooled Model Details; Optional Equipment for M35 Saw; Lubrication and Service Chart

SAW INFORMATION
1. ThisManualprovidesthebasicinstructionsfortheoperationandmaintenanceof
theM0Eelectricconcretesaw.Tocomplywithcodesinyourareaofoperation,youwill
needtoinstalltheappropriate3-phaseplugend.
2. M35 Air-Cooled:
MOTOR: Kohler Command Pro CH980 - 4 - Stroke, air cooled, VTwin,
35hp, Gas
Drive Unit: Hydrostatic Transmission
Water Pump: Self-priming Electric (Optional)
Spindle: 1-3/8” with Tap-base Pillowblock Bearings
Arbor Size: 1” with 1/4” Keys
Blade Capacity: 12 to 24” Diameter
Depth Control: Hydraulic Raise/Lower w/locking stop
Fuel Capacity: 4-Gallons
Weight: 690-Lbs.
Length: 39”
Width: 26.5”
Height: 39”
OPTIONAL EQUIPMENT
1. Bladeguard – Comes with 16” guard. 18”, 20” and 24” available as options.
2. Night Light
3. Electric Water Pump
3. Thenewmachinewastest-runbeforeleavingMorleyEquipmentCompany,
however,theengineshouldbecheckedwiththeEngineManualsothatthe
correctroutineisfollowedatalltimes.Checkallfluidlevels.Thisisvery
importantduringtheinitialrunning-inoftheengineasspecifiedintheEngine
Manual.
4. LUBRICATION/SERVICE CHART
ITEM
HydrostaticTransmission(F/R)
AirFilter
HydraulicPump(R/L)
SpindleBearings
PivotAxle
FrontWheels
CHECK
Monthly
Weekly
Monthly
AsRequired
AsRequired
AsRequired
LUBRICANT
20W-50MotorOil
Serviceasrequired
ATF
Grease
Grease
Grease