8100-35 1
Water Distribution Block
w/Hose Fittings
8181-35 2
Outlet Water Hose - 1/4”
8102-35 1
Inlet Water Hose - 1/2”
8103-35 1
Water Valve
8104-35 1
Mud Flap
8105-35 1
18” Bladeguard
8106-35 1
20” Bladeguard
8107-35 1
24” Bladeguard
BLADEGUARD ASSEMBLY
7100-35 1
Kohler CH980 Command Pro V-Twin - Gas
7103-35 1
Air Filter
7104-35 2
Air Filter Elements
7105-35 2
Hose - 90-Degree
7111-35 1
Throttle Cable
7112-35 1
Choke Cable
7113-35 1
Sheave – 6-groove
7114-35 1
Oil Filter
ENGINE
PART# REQUIRED DESCRIPTION
RAISING SPEED
FLOW CONTROL
VALVE
Just inside the rear access
panel at the lower left side of the
saw is a needle valve that allows
you to adjust the raising speed
imparted by the Raise/Lower
control lever. Your saw comes
with the raise speed pre-set at
the factory. This valve allows you
to reset the speed to suit your
needs.
To Next Page
Loading...