Morpheus Gargoyle - Page 29

Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 29 Morpheus Technologies
Figure 2a Figure 2b
Figure 2: Grasp the canopy and the Tail Pocket so as not to disturb the stowed lines and
slide the cocooned canopy over and into the pack tray ensuring the risers don’t get
twisted. Lay the tail pocket and canopy flat on the bottom of the pack tray with the rear
risers toward the inside. If you have Big Grab toggles, just have them face each other in
the pack tray. Position the canopy squarely and ensure that the tail pocket fills the
bottom comes just short of the bottom of the pack tray. See figure 2a, 2b and figure 3 of
Section 4, Packing the HE or WS-X. Or for traditional closing of the Razor’s Edge, see
figure 5 of Section 4.1: Packing with top flap closing loop.