Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 34 Morpheus Technologies
Section 9: Line & Riser Continuity
Left Rear Left Front Right Front Right Rear
Remember that each connector link has to show continuity from the lines to the canopy.
Check each one for proper assembly.
Each of the links will have four cascading lines. The two control lines each cascade into
five.
Once you have orientated the lines properly on the #5 links, inspect them. Finger-tighten
all 4 connector links. Then apply a
1
/
4
turn with a 9mm wrench. Do not over tighten as this
can strip or crack the link and cause it to fail. Slide the slider bumpers (covers) over the
links.
Note: The slider retainer strap is attached to the left front riser, this strap is used to hold the
slider in position on slider down jumps. When not in use it should simply wrapped around
the riser and held in place using the popper.
To Next Page
Loading...