Morpheus Gargoyle - Page 36

Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 36 Morpheus Technologies
Section 10.2: Toggle assembly – Method 2; Brake lines with pre-installed
toggle attachment loops
Figure 1
Figure 1: Pass the control line through the toggle’s grommet from the Velcro side of the
toggle.
Figure 2
Figure 2: Then thread the bottom of the toggle through the toggle attachment loop,
pulling the slack brake line back through the grommet.
Figure 3
Figure 3: The assembled toggle should look like photo above.