Morpheus Gargoyle - Page 39

Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 39 Morpheus Technologies
Figure 4
Figure 4: S-fold and stow the excess control line to the inside of the riser and around to the
elastic keeper, located on the front side of the rear riser. Check proper routing. Be certain
that the control line leading to the canopy is routed to the outside.
Figure 5
Figure 5 : Be certain that the Velcro on the toggle mates with the Velcro on the riser. Also
make certain that the top of the toggle does not pass through the guide ring.