4
heating time). The OTG will switch ON the
Before first use:
moment the timer knob is set to any
1. Carefully unpack the OTG, accessories,
desired cooking time. After the set time
and printed material. Remove stickers (if
elapses, the power supply to the unit
any, except the rating label).
would shut off automatically. If you desire
to switch off the OTG at any time, turn the
2. Read all the instructions provided in this
timer knob back to OFF position.
manual carefully to familiarise yourself with
the product.
4. Open the glass door after the cooking
function is over, always use the door
3. Wipe the glass door and the inner cavity of
handle.
the OTG with a moist cloth. Wipe again
with a dry cloth.
5. To remove the baking tray, always use the
tong.
4. Place the OTG on a plane and heat
resistant surface. Leave a space of at least
6. For grilling, if you wish to use the skewer
4 inches (100 mm) between the back cover
rods, insert the food onto the skewer rods
of the OTG and the wall.
and place those on “U” shaped notches
provided on the wire grill cum barbeque
5. Insert the power plug into a suitable power
tray, which should be placed on the top
socket and switch ON the OTG by setting
rack. Place the crumb tray at the bottom to
the timer at 10 minutes.
prevent excessive fats / oils from falling on
6. Let the OTG heat up for 10 minutes with
to bottom surface.
function select knob at "toast mode"
position and temperature control knob at
Controls & functions:
0
250 C. A slight smell may be emitted. This
1. Temperature control knob:
is normal in any electrical appliance and
will last only for a short time. Ensure
This knob helps to set the temperature as
sufficient ventilation. Switch OFF the OTG
per the requirement of the recipe.
by turning the timer knob to OFF position
2. Function Select Knob:
after 10 minutes.
This knob is used to set the desired
Instructions for use:
function in the OTG:
a. Toast+Convection ( )
1. Before every use, preheat the OTG for 10
minutes with function select knob at "toast
l
Place the wire rack on the centre rack
mode" position and temperature control
position.
0
knob at 250 C.
l
Set the temperature dial to the desired
2. Pre-heating need not be done for second
position.
and subsequent consecutive cooking
l
Set the timer dial to the desired
operations, if the time between the first and
cooking time.
the second consecut ive cook ing
b. Bake + Convection ( )
operations is lesser than 5 minutes.
l
Place the baking tray on the center rack
3. Set the time with timer knob as per the
position.
requirement of the recipe (exclude the pre
To Next Page
Loading...
