6
Follow the steps as under: 4. Never use metal polish or coarse scouring
agents for cleaning.
Hold the rotisserie tong with both hands.
5. Do not scrub the surface of the cooking
tray with any hard or abrasive material,
Place the tong rods below the rotisserie rod
while cleaning. Use a sponge or nylon
notches, provided at the extreme ends. Lift
scrubber to clean the surface of the
up the left end of the rotisserie rod slightly.
cooking tray. To clean the stubborn food
particles on the cooking tray, make a thick
Push the rotisserie rod towards left so that it
paste of normal washing powder using
comes out of the socket.
little water and apply on the surface. Keep it
for a while, scrub with sponge and wash.
Now lift the right end of the rotisserie rod.
6. Removable wire rack, baking tray, crumb
tra y c a n b e w a s hed as no r m al
Balance the tong with both hands along
kitchenware.
with the food item and rotisserie rod while
removing out the same.
Repairs:
NOTE: The recipes given in the recipe section
Electrical appliances must only be repaired by
are meant as a guideline. The timings and
authorized specialists. Because damages can
temperatures given with the recipes may vary
occur by non-authorized repairs, in the case of
to a certain extent depending on voltage
a repair, contact Morphy Richards service
variations, ingredients used and ambient
center.
conditions.
General cleaning and care:
1. After use and before cleaning, switch-off
the OTG, remove the power plug from the
socket and wait for the OTG to cool.
2. Wipe the glass door and the inner cavity of
the OTG with a moist cloth. Wipe again with
a dry cloth.
3. If any food particle or liquid has spilled,
clean it with a damp cloth and let the
interior dry thoroughly.
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Technical Data:
Power Supply : 230V, AC 50Hz
Wattage : 1500W
To Next Page
Loading...
