16
The sealing ring/gasket
We recommend that the sealing ring be replaced
every one or two years, depending upon the
amount of use.
Do not use a substitute sealing ring otherwise your
guarantee will be invalidated. You can order your
replacement sealing ring for this model from our
website or by calling our customer helpline.
Wash the sealing ring after each use in warm
water and detergent to remove any debris from
both the seal and the groove in which it sits.
The sealing ring lifts out and is put back by
easing in place under the rim of the lid.
Note: If the pressure cooker is not used for a
long period of time, the sealing ring may need
replacing as it can harden and then will not form
an air-tight seal. Replace the seal immediately.
The pressure regulator
The pressure regulator must be cleaned
after each use. After lifting the pressure
regulator off the lid, clean and rinse the
pressure regulator under running water.
If a deep clean is required, gently pull
out the blue silicone part by releasing
it from the 2 small side locks of the black
cap. And reassemble as the image
shows on the left.
Check the bottom blue silicone part is locked
back in and press the bottom of the regulator
to check if the spring is working fine.
Red pressure indicator valve
Turn the lid over, and check that the red pressure
indicator valve moves freely. If the valve requires
cleaning, remove the valve by using a spanner
and turn anti-clockwise. Clean the valve and refit
it correctly and securely.
Storage
Please make sure all parts are thoroughly dried
before storage. After initial use, to avoid damage
to the sealing ring, do not store your pressure
cooker with the cover fitted in place; instead,
place the cover upside down, with the seal
uppermost and store the pressure cooker in
a cool, dry place away from direct sunlight.
4. Cleaning, Maintenance & Storage
To Next Page
Loading...
