11
Your Soup & Milk Maker utilises 3 different
processes to create fresh soups and drinks;
heating, resting and blending. Each of these
processes are highlighted during the program
with a small animation on the LED Screen.
Heating
The heating animation will appear in motion when
the Soup & Milk Maker is heating the contents of
the Soup & Milk Maker Jug.
Blending
The blending animation will be displayed when
the Serrator Blade is in use. When switching from
heating to blending the Soup & Milk Maker will
make a single audible beep.
Resting
During the programs the Soup & Milk Maker will
occasionally ‘rest,’ at which point no
animation will be shown. The timer on the LED
Screen will continue to count down. This is
normal.
Once the process is completed the Soup & Milk
Maker will beep for 60 seconds and the screen
will display the ‘completed’ icon.
Completed
When completed, your Soup & Milk Maker will
show the same animation as resting, but the timer
will be at ‘0’ and all four icons on the panel will
flash.
LED Screen (14)
When the milk is made, pour the contents of
the Soup & Milk Maker Jug
(4) a little at a
time through a fine mesh sieve or nut bag
into a large measuring jug.
Select the Blend Button and then press and
h
old the Select button for 20 seconds. Wait
2 seconds then blend again. Repeat until the
nuts are finely chopped (this should take
around 80 seconds in four 20 second bursts)
Pulp will remain in the sieve, leave to stand
over a bowl for 10-15 minutes to allow the
liquid to filter through. Firmly press with the
back of a spoon to extract a little more liquid.
Nut milks can be pressed firmly through the
sieve but it is not advised for soya milk.
To Next Page
Loading...
Need help?
General
