6
Anti-scale system
The anti-scale cartridge is designed to
reduce the build-up of limescale which occurs
during steam ironing, this will prolong the
working life of your iron. However, please
note that the anti-scale cartridge will not
completely stop the natural process of
limescale build-up.
Using your anti-scale and alert system
This appliance has an electronic system
that monitors the water hardness.
Filling/Refilling your anti-scale cartridge
1 When the anti-scale cartridge indicator
is flashing you will need to replace the
cartridge.
(Towards the end of the useful life of the
cartridge, the warning light will flash briefly
every time the tank is refilled, however,
when the cartridge needs replacing the
light will flash for a longer time, ie.1 minute
or more).
2 If a new cartridge is not available you may
continue operating the appliance but scale
will build up in the system. Replace the
used cartridge as soon as possible.
3 Disconnect the appliance from the mains
outlet.
4 Slide out the water tank and remove the
anti-scale cartridge as shown.
5 Replace with a new anti-scale cartridge
and reinstall the water tank.
Replacement anti-scale refills
To obtain replacement anti-scale refills
telephone our Helpline number
on 08450 777700.
Features of your
steam generator
Temperature indicator light
The indicator light shows that the iron is
warming up. When the required temperature is
reached the light will go out and will cycle on-
off during operation.
Steam function
During the steaming process, small
amounts of water may be ejected from the
soleplate. This is normal and can be avoided
by using the steam for short amounts of time
and only when the iron is at the correct
temperature (the indicator light on the iron
goes out when ready) or reducing the steam
rate by pressing the power button to choose
from; steam off, low, medium or high.
Sudden jolts of the boiler unit can also
cause water droplets on the soleplate;
therefore do not move the base unit during
ironing. We recommend for first time ironing
that you iron over an old towel.
Variable Steam
Fill the iron with water as described in
“Filling”, page 4 and insert the plug into the
electrical socket.
The steam output can be varied from low to
high by pressing the power switch. When
using the iron at the bottom of the temperature
range, the steam output should be adjusted to
the lowest setting.
FILL TO HERE
To Next Page
Loading...
