7
Auto shut-off
When the unit has not been used for 15
minutes it will automatically go to ‘standby’. To
reactivate press the steam trigger or the
power switch.
Thermal protection
If the unit overheats due to excessive
continual usage it will go to ‘standby’ mode (for
your protection).
Allow the unit to cool down, then
re-activate by pressing the steam trigger or
power switch.
Maintenance
To clean the stainless steel soleplate
To keep the soleplate of your iron clean and
free of limescale, we recommend that you use
one of the gentle chrome, silver or stainless
steel cleaners that are generally available.
Always follow the manufacturers instructions.
To clean off melted man-made fibres set the
iron at 3 dot position and pass it over a clean
piece of cotton which will draw the deposit off
the surface.
To clean the exterior
Allow the steam generator to cool and wipe
over with a damp cloth and mild detergent,
then wipe with a dry cloth.
Vertical steam
Hold the iron in a vertical position between
1 cm and 2 cm away from the item . Press
the steam button , this will create vertical
steam. This feature is especially useful for
removing creases from hanging clothes,
curtains, wall hangings, etc.
Emptying and Storing
When you have finished ironing, unplug
your iron.
1 Slide out the water tank and remove the
anti-scale cartridge .
2 Empty the water in the tank
by holding it upside down .
3 Replace the anti-scale cartridge and
reinstall the water tank.
Unplug the generator and leave the iron to
cool off for 15 minutes minimum. The iron must
be placed on the iron rest plate.
The iron and boiler can now be stored
together.
To Next Page
Loading...
