Morso Panther - CHECK FULL OPERATING SEQUENCE; Pilot and Main Burner Ignition

7
See figure 8.
If the firIf the fir
If the firIf the fir
If the fir
e is ture is tur
e is ture is tur
e is tur
ned ofned of
ned ofned of
ned of
f or the flames go out, wait at least 3 minutesf or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutesf or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutes
beforbefor
beforbefor
befor
e attempting to re attempting to r
e attempting to re attempting to r
e attempting to r
elight. A safety device in the contrelight. A safety device in the contr
elight. A safety device in the contrelight. A safety device in the contr
elight. A safety device in the contr
ol stops theol stops the
ol stops theol stops the
ol stops the
firfir
firfir
fir
e being ture being tur
e being ture being tur
e being tur
ned back on until it is safe.ned back on until it is safe.
ned back on until it is safe.ned back on until it is safe.
ned back on until it is safe.
- Turn the left hand control knob fully clockwise.
- Push in the right control knob and, while keeping it depressed, turn
anticlockwise through the ignition position marked and up to the
pilot position marked . The spark should light the pilot.
- If the pilot does not ignite, keep the knob depressed for a few seconds
to purge air from the supply pipes. Then turn back to the off position
marked • and repeat the ignition procedure.
- When the pilot has lit, keep the right hand control knob depressed for a
few seconds to allow the pilot flame to stabilise then release it. If the
pilot does not remain alight ensure that the air has been purged.
- Partially depress the right control knob and turn to the main burner
position marked . The main burner should now light at its low position.
- The left-hand knob is for burner flame adjustment. Turning it
anticlockwise should gradually increase the flame height.
- The flame height control does not have to be re-set every time the fire
is lit. It can be kept at any position enabling the customer to use the
right hand control only to ignite the burner at the set flame height.
- After checking turn the right hand knob to off. Depress the control knob
partially at the pilot position ( ), turn clockwise to off (•) and release
the knob. If any resistance is felt when turning, release the downwards
pressure on the knob before continuing to turn.
CHECK FULL OPERACHECK FULL OPERA
CHECK FULL OPERACHECK FULL OPERA
CHECK FULL OPERA
TING SEQUENCETING SEQUENCE
TING SEQUENCETING SEQUENCE
TING SEQUENCE
FigurFigur
FigurFigur
Figur
e 6e 6
e 6e 6
e 6
FigurFigur
FigurFigur
Figur
e 7e 7
e 7e 7
e 7