Mosa COMAP InteliNano PLUS - 2. START AND STOP ENGINE; AMF in MANUAL mode; MRS in MANUAL mode; AMF in AUTO mode

02/12/16 CM1K90F_IT-EN-DE
ENGLISH
ENGLISH
INTELINANO PLUS
2. START AND STOP ENGINE
2.1 AMF in MANUAL mode
Green LED above
AUTO
button is off (controller is in
MANUAL mode). When there is no any active shut down
alarm you can start the engine by pressing
START
button. Green LED above button will blink. LED is
blinking during starting, cooling or stopping procedure.
When the engine is already started, the green LED will
stop blink and start lights continuously, the generator is
ready to load. When you press
START
button again the
MCB will open. Another press of this button will close
GCB.
Press
STOP
button to stop the engine. First press will
open the GCB, next press will close MCB and next press
start cooling stopping procedure. When you press this
button again the controller will stop engine immediately.
For fast load transfer and the engine stop press and hold
STOP
button till load will be transferred and engine
stops.
2.2 MRS in MANUAL mode
Green LED above
AUTO
button is off (controller is in
MANUAL mode). When there is no any active shut down
alarm you can start the engine by pressing
START
button. Green LED above button will blink. LED is
blinking during starting, cooling or stopping procedure.
When the engine sis already started, the green LED will
stop blink and start lights continuously. The generator
is ready to load. When you press
START
button again
the GCB will close – only when the GCB is congured.
Press
STOP
button to stop the engine. First press
will open the GCB and next press start cooling and
stopping procedure. When you press this button again
the controller will stop the engine immediately. For fast
engine stop press and hold
STOP
button till engine
stops.
2.3 AMF in AUTO mode
Green LED above
AUTO
button is on (controller is
in AUTO mode). You can’t start the engine or transfer
the load by pressing
START
button. The controller will
start automatically when all conditions for start and load
transfer will be reached. The engine in AUTO mode can’t
be stopped by pressing
STOP
button.
Engine can be started or stopped via binary input Remote
Start/stop or Remote Start And Load.
2.4 MRS in AUTO mode
Green LED above
AUTO
button is on (controller is
in AUTO mode). You can’t start the engine or connect
the load by pressing
START
button. The controller will
start automatically when all conditions for start and load
connection will be reached. The engine in AUTO mode
can’t be stopped by pressing
STOP
button.
Engine can be started or stopped via binary input Remote
Start/stop or Remote Start And Load.
23