MOSKO MOTO Reckless 80 Revolver User Manual

X 10
M6 Bolt
Washer
T-nut
Tool
Loctite
Step #1
Place T-nut on backside of center hole in main harness.
(This is easiest on a flat surface!)
Place bolt and washer in front side of leg harness center hole.
Hand tighten for now, keep loose.
M6 Bolt/washer
T-nut T-nut
M6 Bolt/washer
Step #3
Install remaining hardware in leg harness bolt holes and
corresponding main harness holes. (This is easiest on a flat surface)
Hand tighten only, until all hardware has been installed.
Finally tighten hardware using provided key.
Before riding, tighten all straps/bolts and check periodically.
Step #2
Place on motorcycle in desired location.
Revolve legs until they are at desired angle.
Note what lean angle the lean selector arrow is closest to.
Apply a small drop of included
Loctite to the bolts
Rotate, and loosely
attach leg straps
Reckless 80 Revolver
Assembly instructions
Right
Leg harness
Left
Leg harness
Main or Center
harness

MOSKO MOTO Reckless 80 Revolver Specifications

General

Brand	MOSKO MOTO
Model	Reckless 80 Revolver
Category	Motorcycle Accessories
Language	English

Summary

Step #1: Main Harness Attachment

Included Hardware Overview

Lists all components provided for installation.

T-nut and Bolt Placement

Attaching T-nut to main harness and bolt to leg harness.

Step #2: Motorcycle Positioning

Bags Placement and Angle Adjustment

Positioning bags on the motorcycle and adjusting leg angles.

Step #3: Final Hardware Installation

Installing Remaining Hardware

Securing all remaining hardware on main and leg harnesses.

Final Tightening and Checks

Tightening all straps/bolts and periodic checks before riding.

Installation: Strap Routing and Tightening

Rear Strap Routing

Passing rear mounting straps through bike frame or rack.

Leg Strap Routing and Adjustment

Routing leg straps through frame and adjusting for tightness.

Strap Tail Management

Securing excess strap tails with Velcro loops.

Regular Checks Reminder

Importance of checking strap tightness, wear, and loose straps regularly.

Heat Shield Placement

Muffler Heat Shield Installation

Positioning the heat shield to protect bags and plastics from melting.

Heat Shield Verification

Checking heat shield location after each use for proper protection.