8
Assembly Instructions
Step 1
Place base upside down on a at surface, unfold
U-shaped support leg until it locks in place.
Step 3
Place trap power head onto pole. Press down rmly
with two hands to secure.
Assembled trap should have the front of power
head/trumpet placed farthest from the wheels in the
same direction as base U-shaped legs.
Step 2
Turn base and leg assembly right-side-up and place
support pole into cavity on base.
Step 4
The battery is not fully charged at the factory;
charge the battery before the rst use. Under proper
usage, one charge lasts all season. See page 6 for
further details.
Trap Assembly:
Bug Bag Installation:
To insert Bug Bag, rst engage front/open section
then gently push the back end down into place.
OFF
RUN
COOL
WARM
MODE
ATTENTION!
MODE
To Next Page
Loading...
