6
Safety Instructions
• Maintain adequate clearances of 20”–24” around air
openings into the combustion chamber, clearances from
combustible material, provisions for accessibility and for
combustion and ventilating air supply. Keep the trap area
clear and free from combustible materials, gasoline, and
other ammable vapors and liquids. The appliance is not
to be used in locations where ammable vapor or
explosive dust is likely to exist.
• Do not obstruct the ow of combustion and ventilation air.
• Keep the ventilating openings of the cylinder enclosure
free and clear from debris.
• Clean the trap with water and a damp cloth if necessary.
• A maximum of a 20 lb. LP-Gas cylinder shall be used.
• The LP-Gas cylinder must be provided with a shut-off
valve terminating in an LP-Gas supply cylinder valve
outlet specied for Connection No. 510 in the Standard for
Compressed Gas Cylinder Valve Outlet and Inlet
Connections, ANSI/CGA-V-1-1977.
• The LP-Gas cylinder supply system must be arranged for
vapor withdrawal and the cylinder must include a collar to
protect the cylinder valve.
• The LP-Gas cylinder used shall be constructed and marked
in accordance with the specications for LP-Gas cylinders
of the U.S. Department of Transportation (DOT) or The
National Standard of Canada CAN/CSA-B339.
• The trap shall be used outdoors only in a well ventilated
space and shall not be used in a building, garage, or any
other enclosed area.
• The LP-Gas cylinder must be disconnected and removed
from the appliance, if the appliance is stored indoors.
• LP-Gas cylinders must be stored outdoors in a well-
ventilated area out of reach of children.
• Disconnected cylinders must have threaded valve plugs
tightly installed and must not be stored in a building, garage,
or any other enclosed area.
• The pressure regulator and hose assembly supplied with
this appliance must be used for connection to the LP-Gas
cylinder. Replacement pressure regulators and hose
assemblies must be specied by the manufacturer.
• Avoid improper use of extension cords. Keep connections
away from moisture and avoid damage to the cord.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualied
person in order to avoid hazard.
visit www.mosquitomagnet.com
To Next Page
Loading...
