MOTO GUZZI BREVA V1100

Other manuals for MOTO GUZZI BREVA V1100

Workshop Manual155 pages

Service Station Manual229 pages

Questions and Answers

S
Sara JamesJul 29, 2025
What to do if there is oil leakage between the housing and fork on my MOTO GUZZI Motorcycle?
- M
  Mary FaulknerJul 29, 2025
  If you notice oil leaking between the housing and fork of your MOTO GUZZI Motorcycle, several issues could be the cause. It might be due to a damaged boot, in which case you should replace the boot. Another possibility is a loose locking clamp or cover, which requires tightening the clamp with the proper tool. Also, the radial seal might be damaged or incorrectly assembled, so replace and assemble the seal using an appropriate tool. Finally, the running surface of the wheel spacer seal could be damaged, requiring replacement of the spacer.
C
Cheyenne MillerAug 2, 2025
How to fix oil leakage from the oil fill plug or oil drain plug on a MOTO GUZZI Motorcycle?
- J
  Jennifer KingAug 2, 2025
  If your MOTO GUZZI Motorcycle is leaking oil from the oil fill plug or oil drain plug, there are a few potential reasons. First, there might be dirt between the sealing ring and housing; clean the area and tighten the plug to the prescribed torque. Second, an old sealing ring might have been used, so replace it with a new one. Third, the plug might not be tightened to the specified torque; tighten it accordingly.
L
Lindsey SmithAug 7, 2025
Why is my MOTO GUZZI Motorcycle leaking oil from the wheel shaft?
- C
  cynthiawilliamsAug 7, 2025
  Oil leakage from the wheel shaft on your MOTO GUZZI Motorcycle can be attributed to a couple of reasons. One potential cause is a radial shaft seal that is either incorrectly mounted or damaged; in this case, replace and correctly mount the radial shaft seal. Alternatively, the running surface of the wheel shaft seal might be damaged, necessitating replacement of the wheel shaft.
D
Deborah NelsonAug 11, 2025
What causes oil leakage from the housing of a MOTO GUZZI Motorcycle and how to fix it?
- E
  Erin HendricksAug 11, 2025
  If your MOTO GUZZI Motorcycle has oil leaking from the housing, it could be due to a couple of reasons. First, the housing might not be sealed properly; in this case, open and seal off the half-housings with sealant. Second, the bolts might not be sealed off or tightened to the specified torque; tighten the bolts to the specified torque.
V
Victoria MitchellAug 15, 2025
How to resolve oil leakage from the outer boot of my MOTO GUZZI Motorcycle?
- J
  jpatelAug 15, 2025
  If you're experiencing oil leakage from the outer boot of your MOTO GUZZI Motorcycle, it could be due to a damaged boot, which requires replacement. Alternatively, the outer or inner locking clamp might be loose; lock the clamp using an appropriate tool.
B
Beverly WilliamsAug 19, 2025
Why is my MOTO GUZZI Motorcycle's bevel gear group making noise?
- B
  bethany50Sep 12, 2025
  If the bevel gear group in your MOTO GUZZI Motorcycle is making noise, it could be due to a couple of issues. The bevel gear might be incorrectly assembled, requiring replacement. Alternatively, the gear crown toothing might be damaged, also necessitating replacement of the bevel gear.
D
david83Aug 25, 2025
What causes excessive wheel shaft backlash in a MOTO GUZZI Motorcycle?
- L
  Leah BellAug 25, 2025
  Excessive wheel shaft backlash in your MOTO GUZZI Motorcycle is likely due to damaged wheel shaft ball bearings. The solution is to replace the wheel bearings.

MOTO GUZZI BREVA V1100 Specifications

General

Displacement	1064 cc
Fuel System	Electronic fuel injection
Transmission	6-speed
Final Drive	Shaft
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Fuel Capacity	22 liters
Engine Type	V-twin, four-stroke
Bore x Stroke	92 mm x 80 mm
Front Suspension	Telescopic fork
Rear Suspension	Single shock absorber
Front Brakes	Dual 320 mm discs
Rear Brakes	282mm disc, 2 piston caliper
Wheelbase	1490 mm
Seat Height	800 mm
Cooling System	Air cooled