Motoalliance DENALI User Manual

Professional Series Hydraulic Turn System
P/N: HYPro 22000 Industrial Blvd Rogers, MN 55374
866.527.7637
www.motoalliance.com
866.527.7637 (toll free) 1 motoinfo@motoalliance.com
Thank you for purchasing MotoAlliance’s top-of-the-line Hydraulic Turn System! Your
DENALI Hydraulic Turn System was designed for speed, convenience and strength.
The system comes sealed from the factory and requires no maintenance, no hydraulic
fluid, and best of all, a hassle-free install! The DENALI Hydraulic Turn System has
built in bypass valves that will protect the pump and cylinder from being over
pressurized. However, this does not replace the need for common sense and extreme
caution when using this powerful system. Always pay attention to your surroundings
and heed the follow precautions. Most of all, enjoy not having to get out in the cold
each time you want to turn your blade!
Warning And User Caution
- Do not continually force the hydraulics to run once the blade is fully
turned in one direction
- Never allow passengers to ride on the blade while plowing
- Stay clear of bystanders while plowing
- Do not exceed 10 MPH with blade installed
- Always wear safety gear (helmet, glasses, etc) when plowing
- Use extreme caution when plowing and riding on sloped surfaces
- Avoid all fixed objects and always wear a seatbelt
- Be cautious of the blade when lowering it from an upright position
- Always store your blade resting on the ground

Motoalliance DENALI Specifications

General

Brand	Motoalliance
Model	DENALI
Category	Snow Blower Accessories
Language	English

Summary

General Warnings and User Cautions

Assembly and Installation

Remove Pivot Lock Lever and Brackets

Remove pivot lock lever and riser brackets using specified bolts and spring.

Remove Pivot Lever Support Bracket

Remove the pivot lever support bracket using specified bolts.

Install Hard Stop Bracket

Replace the pivot lever support bracket with the hard stop bracket using specific bolts.

Mount Swivel and Lift Arm Brackets

Mount swivel plate and lift arm brackets with specific bolts, washers, and nuts.

Mount Hydraulic Pump

Secure the hydraulic pump to the swivel and lift arm brackets using specified hardware.

Electrical Setup and Wiring

Contactor Mounting and Power Routing

Mount the contactor and route power cables, considering location for optimal protection.

Hydraulic Pump and Contactor Connections

Connect hydraulic pump harness to contactor and power cables to battery terminals.

Switch Wiring and Power Source

Connect switch wires to contactor and a keyed power source using specified connectors.

Wiring Verification and Securing

Verify wiring correctness by testing the switch and secure all loose wires.