EasyManua.ls Logo

Motocaddy M7 REMOTE - Charging and Caring for Lithium Battery; Charging Your Lithium Battery

Motocaddy M7 REMOTE
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 8
Charging your Lithium Battery / Lithium Battery Care
Charging your Lithium Battery
1. Unplug the Lithium battery from the trolley. This should always be performed before folding the trolley to avoid damage
to the battery and/or trolley
2. Plug the charger into your mains supply
3. Attach the battery cable to the charger matching black to black and grey to grey
4. When the charging LED indicator has turned green, the battery is fully charged and ready to be used
RED - Battery charging GREEN - Battery fully charged and ready to be disconnected
5. The charging process will take between 3 to 5 hours depending on the depth of discharge
(please be aware that this may take longer for the rst few charges)
6. Once charging is complete please disconnect the charger from the mains power supply
7. Finally disconnect the charger from the battery
If you connect the battery to the charger and the LED goes out, this is likely to indicate that the battery is fully charged.
Please double check the battery on the trolley to ensure that it is fully working.
Caring for your Lithium Battery
Try to avoid getting the battery too wet (i.e. do not submerge the battery, avoid deep puddles and do not clean
your trolley whilst the battery is still in the battery tray)
Dropping the battery may cause damage to the internal cells
Do not lift or carry the battery by the cable
Use a damp cloth to clean off any dirt

Related product manuals