5
Troubleshooting
(*) Normally, repositioning the battery pack resolves the issue.
(**) Battery is either too warm, too cold or using wrong power
voltage.
If there is no LED indication, perform the following actions:
1. Check if the radio with battery, or the battery alone is
inserted correctly. (See “Charging Procedure”).
2. Plug the power cord into the charger and use an
appropriate AC outlet.
3. Confirm the battery used with the radio is listed in Table 1.
Service
The Multi-Unit Charger is not repairable.Order a
Replacement Charger if necessary.
ADDITIONAL INFORMATION
The complete Online User Guide (Motorola Solutions Publication
part number: MN009980A01) is available at:
https://learning.motorolasolutions.com
Table 3: Charging LED Indication
LED Indication Status
Green for approximately 1 second Power On
Steady red Charging
Flashing green Charging >90%
Steady green Fully Charged
Flashing red Error (*)
Flashing yellow Standby (**)
Steady red Charging
MN010108A01.book Page 5 Wednesday, August 2, 2023 11:02 AM