Hardware Installation
9
A separate Power Injector is required for each AP-5131 comprising the network.
The Power Injector can be installed free standing, on an even horizontal surface or wall mounted
using the power injector’s wall mounting key holes. The following guidelines should be adhered to
before cabling the Power Injector to an Ethernet source and an AP-5131:
• Do not block or cover airflow to the Power Injector.
• Keep the Power Injector away from excessive heat, humidity, vibration and dust.
• The Power Injector is not a repeater, and does not amplify the Ethernet data signal. For
optimal performance, ensure the Power Injector is placed as close as possible to the
network data port.
to AP-5131 LAN
Port
Data Power
AP-5131
Power
Injector
Wireless LAN
72-70931_01.book Page 9 Monday, May 4, 2009 8:10 AM
To Next Page
Loading...
