Motorola AP-5131 - Configuring Basic Device Settings

Basic AP-5131 Configuration
25
4.2 Configuring “Basic” Device Settings
Configure a set of minimum required device settings within the AP-5131 Quick Setup screen. The
values defined within the Quick Setup screen are also configurable in numerous other locations
within the AP-5131 menu tree. When you change the settings in the Quick Setup screen, the values
also change within the screen where these parameters also exist. Additionally, if the values are
updated in these other screens, the values initially set within the Quick Setup screen will be updated.
The following table illustrates the changes made to the access point’s default configuration.
To define a basic AP-5131 configuration:
Version 1.0 Version 1.1
Version 1.1.1.0
& 1.1.2.0 Version 2.0
WAN DHCP client
Auto-Update
Enabled
Static IP: 10.1.1.1
Static Mask:
255.0.0.0
Static IP: 10.1.1.1
Static Mask:
255.0.0.0
Static IP: 10.1.1.1
Static Mask:
255.0.0.0
LAN 1 Static IP:
192.168.0.1
Static Mask:
255.255.255.0
DHCP Server
Enabled
DHCP Client
Auto-Update
Enabled
Default Gateway
Ethernet Port
Enabled
DHCP Client
Auto-Update
Enabled
Default Gateway
Ethernet Port
Enabled
DHCP Client
Auto-Update
Enabled
Default Gateway
Ethernet Port
Enabled
LAN 2 Not applicable in
1.0 release
Static IP:
192.168.1.1
Static Mask:
255.255.255.0
DHCP Server
Enabled
Disabled Disabled
Access
via
WAN
port
HTTPS, SSH, SNMP:
Enabled
HTTP, HTTPS, SSH,
SNMP, Telnet:
Enabled
HTTP, HTTPS, SSH,
SNMP, Telnet:
Enabled
HTTP, HTTPS, SSH,
SNMP, Telnet:
Enabled
72-70931_01.book Page 25 Monday, May 4, 2009 8:10 AM