AP-6521 Series Access Point Installation Guide
28
• The port connected to the WAN - Select the port used as the physical access point
connection to the external network. This ports available differ depending on the access
point model deployed. Access point models with a single port have this option fixed.
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between
the access point's WAN and LAN interfaces.
16. Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to
define support for the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality
as a dedicated sensor. An AP-6521 is supports a single dual-band radio.
NOTE The ADSP Sensor Support field displays at the bottom of the screen
only if a radio has been dedicated as a sensor.
To Next Page
Loading...
Need help?
General
