Installation Guide 23
5. Click the Login button to load the management interface.
6. Select the Start Wizard button to run the initial setup wizard.
The setup wizard displays the first time the AP6522 user interface is accessed in order to define the
AP6522’s initial configuration.
7. If this is the first time the management interface has been accessed, a dialogue displays to start the
wizard. Select Start Wizard to run the wizard.
NOTE When logging in for the first time, you’re prompted to change the
password to enhance device security in subsequent logins.
NOTE If you get disconnected when running the wizard, you can connect again
with the access point’s actual IP address (once obtained) and resume the
wizard.
To Next Page
Loading...
Need help?
General
