EasyManua.ls Logo

Motorola APX 8000XE 1.5 - Chapter 2: Getting Started; Initial Setup and Basic Operations

Motorola APX 8000XE 1.5
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2
Getting Started
This section provides instructions to prepare your radio for use.
2.1
Charging the Battery
Prerequisites:
WARNING: To avoid a possible explosion:
Do not replace the battery in any area labeled hazardous atmosphere.
Do not discard batteries in a fire.
When and where to use: Motorola Solutions-approved battery shipped with your radio is uncharged.
Prior to using a new battery, charge it for a minimum of 16 hours to ensure optimum capacity and
performance. For a list of Motorola Solutions-authorized batteries and chargers available for use with
your radio, see Accessories on page 77.
NOTE: When charging a battery attached to a radio, the radio must be turned off.
Procedure:
To charge the battery, place the battery (with or without the radio) in a Motorola Solutions-
approved charger.
The LED on the charger indicates the charging progress. For more information, see the Charger
User Guide.
2.2
Attaching the Battery
If your radio is preprogrammed with volatile-key retention, the encryption keys are retained for
approximately 30 seconds after battery removal. Check with your dealer or system administrator for
more information.
MN002667A01-AV
Chapter 2 : Getting Started
14

Table of Contents

Related product manuals