18
Visor Microphone Installation
Note: When connecting the Visor Microphone (RMN5054) to the APX VA, do
not connect any wire of the Visor Microphone to pin 17 of Connector J1
on the APX VA. The instructions to do this in the IMPRES Visor
Microphone User Guide do not apply to the APX VA product. Two other
wires should be connected to pins 1 and 23 as instructed.
1. Referring to Figure 4, clip the microphone to the vehicle’s visor.
2. To avoid visual or physical obstruction, route the microphone cable down
inside the door molding and beneath the seat. Allow sufficient slack in the
connector end of the cable to reach the APX VA.
Figure 4: Visor Microphone Installation Detail
Antenna Installation
IMPORTANT: To ensure optimum performance and compliance with RF
Energy Safety Standards, these antenna installation guidelines and
instructions are limited to metal body vehicles with appropriate ground planes
and take into account the potential exposure of back seat passengers and
bystanders outside the vehicle.
Selecting an Antenna Site/Location on a Metal Body Vehicle:
1. External installation – Check the requirements of the antenna supplier
and install the vehicle antenna external to a metal body vehicle in
accordance with those requirements.
2. Roof top – For optimum performance and compliance with RF Energy
Safety Standards, mount the antenna in the center area of the roof.
3. Trunk lid – On some vehicles with clearly defined, flat trunk lids, the
antennas (see the following restrictions) can also be mounted on the
center area of the trunk lid. For vehicles without clearly defined, flat trunk
lids (such as hatchback autos, sports utility vehicles, and pick-up trucks),
mount the antenna in the center area of the roof.
Visor Hands-Free
Microphone
MN000350A01.book Page 18 Tuesday, March 29, 2016 2:14 PM
To Next Page
Loading...
