30
The LED does not light. The
radio will not detect the APX
VA. If the APX VA is attached
to the radio, it will disconnect
itself from the radio.
Note: In some cases, the LED
might intermittently flicker.
The APX VA has
experienced a failure.
1. Turn the radio off.
2. Remove the radio from the
APX VA.
3. Reinsert the radio.
4. The LED will show charging
status in a few seconds. If it
does not, the APX VA requires
factory service.
Difficult to depress the APX
VA engage button and
disengage button during radio
installation and extraction.
The APX VA mechanism
does not move after
installation.
Check that the correct mounting
screws were used. These are the
ones that are shipped with the
APX VA.
Condition Description Remedy
MN000350A01.book Page 30 Tuesday, March 29, 2016 2:14 PM
To Next Page
Loading...
