ASTRO
®
XTS™ 2500 Model III
57
Universal Connector Cover
The universal connector cover protects the side
connector near the antenna.
To remove the cover:
1. Turn the radio off.
2. Carefully insert a flat-bladed screwdriver between the
bottom of the cover and the connector.
3. Holding the top of the cover with your thumb, push the
screwdriver gently downward and lever the cover away
from the radio.
To install the cover:
1. Turn the radio off.
2. Insert the hooked end of the cover into the slot above
the connector.
3. Rub the ball of your thumb from the top to the bottom
of the cover, applying pressure towards the radio. This
will flex the cover and snap it into place.
To Next Page
Loading...
