7
Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside of
the base.
2. Plug the power adaptor with clear connector into the socket marked
on
the underside of the base and plug the other end into the mains power wall
socket. Switch on the mains power.
Installing and charging the handset
1. Remove the battery cover from the back of the handset and insert the
rechargeable Ni-MH battery cells supplied. Please note the ’+’ and ’-’ markings
inside the battery compartment and insert in the correct direction.
2. Slide the battery cover back into place.
3. If you are charging the batteries for the first time, place the handset on the
base to charge for at least 16 hours continuously.
4. When the handset is fully charged,
icon will appear steady on the display.
Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
Press
down
1
Slide
2
To Next Page
Loading...
Need help?
General
