24 Clock & Alarm
6. Clock & Alarm
If you subscribe to your network’s Caller Identification service,
the time on your CD2 may be set automatically each time you
receive a call, depending on your network provider.
You can also set or adjust the time using the Clock & Alarm
menu.
6.1 Set date and time
1.
Press m and scroll d to
CLOCK/ALARM
. Press
m. Display shows
DATE & TIME
, then press m.
2.
Enter the date using the format
DD/MM
e.g.
04/ 08
for 4th
August.
3.
Press m and enter the time using the 24 hour
format
HH:MM
, e.g. 14:45 for 2:45pm.
4.
Press m to confirm.
5.
Press > to return to standby.
NOTE
The date and time is retained during a power failure or when
the batteries are discharged.
6.2 Set alarm
1.
Press m, scroll d to
CLOCK/ALARM
and press m.
2.
Scroll d to
SET ALARM
and press m.
3.
Scroll u or d to
OFF
,
ON ONCE
or
ON DAILY
and press
m.
4.
If you select
ON ONCE
or
ON DAILY
, enter the time using the
24 hour format
HH - MM
e.g 14:45 for 2:45pm and press
m.
5.
Press > to return to standby. When the alarm goes off,
press any key to stop the ring.
NOTE
Once the alarm is set to on, the
J icon is displayed.
The alarm will ring at the medium level.
ALARM ON
and the J
will flash on the display.
6.3 Set alarm melody
There are three alarm ringtones.
1.
Press m and scroll d to
CLOCK/ALARM
.
Press
m.
2.
Scroll d to
ALARM TONE
and press m.
Melodies are played.
3.
Scroll u or dand press m.
To Next Page
