Chapter 5
Radio Cloning
This feature allows you to clone radio settings from one radio to another.
5.1
Clone Radio Settings
You can copy the radio settings from the source to another radio.
You can use one of the following unit chargers and cables for cloning:
• CLR Series Single-Unit Charger (SUC) kit part number PMLN7141_ and CLR Series Cloning Cable
kit part number HKKN4028_.
•
CLR Series Multi-Unit Charger (MUC) kit part number PMLN8250_ (optional accessory).
The MUC does not have to be plugged in for cloning, but both radios require charged batteries.
5.2
Configuring Cloning Mode
Procedure:
Press Power→PTT→Volume Down buttons at the same time.
Table 15: Cloning Mode
After initiation, the radio sounds the cloning mode tone and a double yellow flash to indicate that
the radio is now ready to clone.
5.3
Cloning Radios using the Single-Unit Charger
Prerequisites:
• A fully charged battery on each radio.
MN007428A01-AB
Radio Cloning
31
To Next Page
Loading...
Need help?
General
