_Series Programming Quick Reference
To enter programming mode, press and hold Push to Talk
and
Qfor 3 seconds while turning the radio on. The radio
beeps and displays
k, the channel number flashes, and the
frequency (indicated by
l) and code (indicated by y)
display alternately.
Set the
Channel*
Press
[
or
]
.
Set the
Frequency
Press
S
until
l displays.
Press
[
or
]
to change the
frequency.
Set the
Interference
Eliminator
Code
Press
S
until
y
displays.Press
[
or
]
to change
the code.
Set
Available
Channels*
Press
S
until = displays.
Press
[
or
]
to select
number of available channels.
* CLS1410 Only
_Series Programming Quick Reference
Set a Call
Tone
Press
S
until E display.s
Press
[
or
]
to select1, 2, or
3 for audible call tones, 4 for
VibraCall, or 0 for off (default).
Set the
Microphone
Gain
Press
S
until g and ? display.
Press
[
or
]
to select:
1 Low sensitivity
2 Medium sensitivity
3 High sensitivity
Edit the
Scan List*
Press
S
until h displays and the
channel number and
Y or n flash.
Press
[
or
]
to select the
channel, then press
T
to select Y
(include channel) or n (exclude
channel).
To Next Page
Loading...
