Customer Programming Mode
34
To program, connect the CLS Series radio via the Drop-in Charger Tray and CPS
Programming Cable to your computer as shown in the picture above. Prior to
programming, verify that the switch in the Programming Cable is in the ‘Analog(**)’
position.
CPS allows you to easily program features such as frequency configuration,
programming frequencies, PL/CTCSS codes, as well as other features such as: Call
Tones, Reverse Burst etc. For more information, refer to Features Summary Chart
Section.
Note:
(*) CPS Programming Cable P/N# is HKKN4027_.
(**) If your CPS Programming Cable is showing “CPS / Flash”, make sure to position
it to “CPS”.
6864110W15_.book Page 34 Wednesday, April 26, 2023 2:56 PM
To Next Page
Loading...
Need help?
General
