Motorola D700 series - Babysit Mode On;Off; Backlight On;Off; Switch Call Barring On;Off

16 Advanced settings
Babysit mode on/off
Leave one handset in a room and use another handset to hear sounds in that room.
1. Press m, scroll d to PERSONAL SET and press m.
2. Scroll d to BABYSIT MODE . Press m.
3. Press u or d to select ON or OFF .
4. Press m to confirm.
When switched On, you can leave this handset in the room you wish to monitor. Only the
microphone is on. Anyone in the room cannot hear you.
Babysit
1. Switch a handset’s babysit mode setting On and place that handset in the room.
2. At a second handset, press I and enter the number of the handset you are using as a room
monitor. You can now hear sounds coming from the room.
TIP
To stop room monitoring at any time, press >
Backlight on/off
1. Press m, scroll d to PERSONAL SET and press m.
2. Scroll d to BACKLIGHT . Press m.
3. Press u or d to select ON or OFF .
4. Press m to confirm.
Keypad lock
Prevent accidental dialling while carrying the handset by locking the keypad.
1. Press and hold *.
- The display shows KEYS LOCKED .
2. To unlock the handset, press and hold * again.
NOTE
While the keypad is locked, you can answer incoming calls as normal.
8. Advanced settings
This setting is useful to access certain network and PABX/switchboard services.
Recall time
The default D701 recall time is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
1. Press m, scroll d to ADVANCED SET and press m.
2. RECALL TIME is displayed. Press m.
3. Press u or d to select the setting you want: SHORT , MEDIUM , LONG .
4. Press m to confirm.
5. Press > to return to standby.
NOTE
The use of your D701 cannot be guaranteed on all PABX.
Dial mode
The default D701 dialling mode is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
1. Press m, scroll d to ADVANCED SET and press m.
2. Scroll d to DIAL MODE . Press m.
3. Press u or d to select TONE or PULSE .
4. Press m to confirm.
5. Press > to return to standby.
Temporarily switch from Pulse to Tone dialling
1. Press and hold *.
The dial mode will change from Pulse to Tone for the duration of the call.
Call barring
Prevent certain numbers from being dialled from your D701. Store up to four specific numbers,
each up to 4 digits – for example, international or local prefixes.
Bypass call barring by switching the setting Off or On.
NOTE
If you switch Call barring on, BARR MODE ON will be displayed on your screen in standby mode.
Switch call barring on/off
1. Press m, scroll d to ADVANCED SET and press m.
2. Scroll d to CALL BARRING . Press m.
3. Enter the master PIN (default setting 0000) and press m.
4. MODE is displayed. Press m.
5. Press u or d to select ON or OFF . Press m to confirm.
6. Press > to return to standby. You can now set the number
(See below).
D701_IFU_EN_for_EU.book Page 16 Friday, August 24, 2007 5:19 PM