4
English
RADIO OVERVIEW
English
Programmable Buttons
The programmable buttons consist of:
• Side Programmable Button 1
• Side Programmable Button 2
The following functions can be assigned as short press
i.e. press and release; or long press i.e. press and hold for
more than 1 second.
Button Function
Battery Indicator Shows the current battery charge level as
long as the button is pressed. Refer to
"Battery Level Indicator" on page 3.
Monitor Monitors the channel for any activity as long
as the button is pressed.
Nuisance
Channel Delete
Removes unwanted channel(s) temporarily
from scan list during Scan. Applicable for
Long Press only.
TPL/DPL Enable Enables or disables radio from requiring
matching TPL/DPL to unsquelch.
Power Level Selects required power level: High or Low.
PTT ID Enable Enables or disables PTT ID sent on PTT
press.
Reverse Burst Selects the Reverse Burst Type: None, 180
or 240.
Channel Scan Starts or stops Channel Scan.
Scrambling Code
Select
Toggles between the two scrambling codes
available.
Scrambling
Enable/Disable
Enables or disables Voice Inversion
Scrambling feature for the selected channel.
Applicable for Long Press only.
Squelch Level Selects desired squelch level: Normal or
Tight.
Sticky Monitor Toggles the permanent monitor function until
the button is pressed again. Applicable for
Long Press only.
Talkaround/
Repeater Mode
Enables toggle between repeater and
talkaround mode operations.
Unassigned No function is programmed to this button.
Volume Set Controls the audio level. The button emits a
continuous tone to indicate the current
volume level. To change volume level, turn
the volume knob to the desired level while
pressing the programmable button.
Applicable for Long Press only.
VOX Enables or disables VOX feature for the
selected channel.
Button Function
To Next Page
Loading...
Need help?
General
