16
English
GETTING STARTED
Attaching the Side Connector Cover
TURNING THE RADIO ON OR OFF
1 Place the loop (attached to the side connector
cover) over the antenna; then slide it down-
ward until it touches the top of the radio.
2 Insert the tab on the top of the cover into the
slot above the connector.
3 Position the cover over the connector and
align the thumbscrew with the threaded hole
in the radio.
4 Tighten the thumbscrew to hold the cover in
place. Do not overtighten the thumbscrew.
Thumbscrew
Loop
Antenna
Slot
1 Tur n t he On/Off/Volume (see page 15) knob
clockwise to turn on the radio. You will hear
the Self Test Pass Tone and see a green
LED if the radio powers up successfully. If
the radio fails to power up, you will hear the
Self Test Fail Tone.
2 Tur n t he On/Off/Volume knob (see page 15)
counter-clockwise, until a click is heard, to
turn off the radio.
ON OFF
03_GettingStarted.fm Page 16 Friday, July 22, 2005 11:12 AM
To Next Page
Loading...
