Radio Mounting
Radio Installation 1-7
6.
Mount the antenna using the instructions provided with the antenna kit. Run the coaxial cable
to the radio mounting location. If necessary, cut off the excess cable and install the cable
connector.
Figure 1-3
Radio into Trunnion .
7.
Connect the antenna cable connector to the radio antenna connector on the rear of the radio
(see Figure 1-4).
8.
Mount the microphone clip to a convenient spot near your radio.
9.
Plug the microphone into the control head connector. Your microphone has a telephone type
connector at the end of its cord.
10.
To complete your radio installation plug the power cable into the radio power connector (see
Figure 1-4).
Figure 1-4
Connections to Radio rear.
Thumb
Screw
Trunnion
Thumb
Screw
Antenna
connector
To battery
+ via fuse
F1 (red)
Vehicle
chassis
ground
(black)
Power
connector
Accessory
connector
To Next Page
Loading...
