Need help?Do you have a question about the Motorola GM360 and is the answer not in the manual?
General| Power Output | 1-25 W (VHF), 1-25 W (UHF) |
|---|---|
| Signaling | MDC1200, Quick Call II, DTMF |
| Channel Spacing | 12.5/20/25 kHz |
| Frequency Range | 403-470 MHz |
| Display | Alphanumeric |
| Battery Life | Not applicable (mobile radio) |
Details the physical controls of the radio, including knobs and buttons.
Instructions for using the keypad microphone for clear communication.
Explains how radio buttons can be programmed for specific features.
How to monitor channels or cancel calls and scans.
Function to make individual or group selective calls.
Accessing and managing a list of unanswered calls.
Accessing stored contact information for calls.
Accessing and managing status messages for calls.
Navigating and selecting radio channels.
Starting and stopping the channel scanning operation.
Deleting unwanted channels during scanning or cancelling voice messages.
Adjusting the radio's transmit power between High and Low.
Direct radio-to-radio communication without a system.
Activating an emergency alarm sequence with a pre-recorded message.
Locking and unlocking keypad and menu keys to prevent accidental presses.
Placing the keypad microphone into permanent DTMF live dial mode.
Direct channel access via single button press.
Recording or playing back calls, emergency messages, or memos.
Description of the numeric and function keys on the microphone.
How to lock and unlock the keypad to prevent accidental key presses.
Explains the function of the Exit, Up, Down, Left, Right, and Menu/Select keys.
Used to enter and make selections within the radio's menu system.
Used to move up menu levels or exit the menu mode.
Used for scrolling through lists or channels.
Visual guide showing how to navigate through the radio's menu options.
Describes the main display showing channel, menu, and status information.
Explanation of symbols and icons displayed for radio status.
Lists various tones and their meanings, like power up, errors, and call alerts.
Explains the meaning of different LED colors and patterns (e.g., green, red, yellow).
Step-by-step instructions for powering the radio on and off.
Describes messages displayed during radio startup and self-test.
How to increase or decrease the radio's audio volume.
How to assign channels to programmable buttons for quick access.
Step-by-step guide to making a radio call using the PTT button.
Explains channel busy indications and transmit limitations.
Procedures for selecting a specific channel via number or alias.
Methods to access and navigate channel selection modes.
How to hear and respond to incoming radio calls.
Procedures for canceling a call setup or an active call.
How to properly terminate an ongoing radio conversation.
Making and receiving calls to specific individuals or groups.
Steps to initiate a call to a specific radio or group.
How to identify and answer incoming selective calls.
Methods to enter and use the radio's contact list.
Procedures for choosing a contact by alias or number.
Methods to confirm a selected contact address for a call.
How to edit or delete digits in contact numbers or status entries.
How unanswered calls are stored and managed in the list.
Procedures for accessing and interacting with the missed call list.
Instructions on how to redial numbers from the missed calls list.
How to remove entries from the missed call list.
Explanation of status codes for transmitting prearranged messages.
Steps to send a status message to another radio.
How to identify and interpret incoming status calls.
How to trigger an emergency call with a single button press.
Methods to cancel or end an active emergency call.
Introduction to Dual Tone Multi Frequency for telephone system interfacing.
Procedures for initiating DTMF calls via automatic system connection.
Steps for initiating DTMF calls using manual dialing codes.
How to enable continuous DTMF live dial mode via button or menu.
Instructions for toggling permanent DTMF mode on and off.
Steps to enable or disable DTMF mode through the menu system.
Overview of voice storage capabilities for memos and emergency messages.
Recording and playback of incoming calls or memos up to 2 minutes.
Step-by-step guide to recording a personal memo using voice storage.
Instructions for playing back stored voice recordings.
How to delete individual voice recordings from storage.
How to record a message for automatic transmission during an emergency call.
How to use the radio audio for a public address system via external speaker.
How the feature mutes car audio for clear radio reception.
Introduction to programmable utilities accessible via button or menu.
Explanation of DTMF functionality and mode switching.
How to initiate or terminate channel scanning.
Instructions for operating the Scan button to start/stop scanning.
Steps to control scan functionality through the menu.
How priority channels are checked more frequently during scanning.
Responding to calls received during a scan operation.
Temporarily removing unwanted channels from a scan list.
Restoring previously deleted nuisance channels to the scan list.
How to enable or disable call forwarding using a dedicated button.
Steps to manage call forwarding through the radio's menu.
How to enable or disable talkaround mode using a dedicated button.
Steps to manage talkaround mode through the radio's menu.
How to activate/deactivate the external alarm for incoming calls.
Steps to manage the external alarm feature through the menu.
How to enable/disable the lone worker safety feature using a button.
Steps to manage the lone worker feature through the radio's menu.
How to switch between high and low transmit power levels.
Steps to manage transmit power levels through the menu.
How to enable/disable audio signal compression for improved clarity.
Steps to manage companding settings through the radio's menu.
How to turn the display and key backlight on or off.
Steps to manage backlight settings (on, off, timed) via the menu.
How to adjust the display and key brightness levels via the menu.
How to enable or disable installed option boards.
Steps to manage option board settings through the menu.
How to connect and begin using the hands-free VOX accessory.
How to reactivate the VOX feature after disabling it.
Security feature to disable a radio remotely or return it to use.
How to view software and codeplug version/part numbers via the menu.
Details on retrieving SW/CP versions and part numbers.
Instructions for safe and efficient use of Motorola two-way radios.
Information on human exposure to RF EME and relevant standards.
Warnings and precautions regarding EMI and compatibility.
General operational warnings, including for vehicles with airbags.
Safety advice for operating radios in potentially explosive environments.
Warnings about radio use near blasting caps and in designated areas.
Minimum safe distances for human exposure during mobile radio transmission.
Guidelines for installing vehicle antennas according to manufacturer specifications.
Recommendations for antenna placement for control station use.
Instructions on how to clean and maintain the radio exterior.
Warning against using non-approved radio accessories to avoid damage.
To Next Page
