Motorola GM360 User Manual

14
English
GETTING STARTED
Selecting a Radio Channel
Your radio offers up to 255 channels, however some
may not be programmed. Check with your dealer for
more information.
Before selecting a channel ensure your radio is in
channel mode.
Note: The keypad microphone and Up/Down keys
IDLE states are programmable and may be set
to channel mode.
There are two ways to enter channel mode:
Method 1
Press the Channel Mode direct access button, if
programmed by your dealer.
Method 2
Note: After a short period of inactivity the radio
returns to the IDLE STATE.
Once in channel mode, there are two ways to select
a channel:
Method 1
Method 2 (Keypad Microphone only)
Note: The keypad microphone can’t be used to enter
the channel number during a call or whilst the
radioisina scan.
1 c to enter Menu Mode
2 + or e until:
3 c to select
4 Displayshowse.g.:
Channel
Chan: 05
1
+ or e until:
or
Note: If the + or e is pressed and held, the radio
will fast scroll through the available channels.
2 c to confirm your selection.
(If channel list is entered via the menu.)
Display shows:
(for 2 seconds)
1 Enter the desired
channel number from
the keypad, e.g. 05:
2 c to confirm your selection.
Display shows:
(for 2 seconds)
Channel Number
Alias
Selected
CH: 05
Selected

Motorola GM360 Specifications

General

Power Output	1-25 W (VHF), 1-25 W (UHF)
Signaling	MDC1200, Quick Call II, DTMF
Channel Spacing	12.5/20/25 kHz
Frequency Range	403-470 MHz
Display	Alphanumeric
Battery Life	Not applicable (mobile radio)