6
Communication Procedures
English
Receiving a Selective Call
When a call is received, the alert tone for individual call
or group call is heard, and the yellow indicator (4)
flashes, fast for individual call and slow for group call.
The address of the incoming caller will be flashing on the
display if your radio is programmed with the Caller
Identity feature.
Call Back:
Pressing the defined call button or PTT will automatically
‘call back’ to this number
if your radio is programmed
with the Call Back feature.
Please contact the person in charge of your radio
system or your local Motorola representative for
further information.
Call in Absence
If a call is not answered within a preprogrammed
amount of time, the call will be stored by the radio.
Up to 10 calls can be stored in the stack. If the
same radio calls more than once the call is only
stored once. When 10 calls have been stored by
the radio, the eleventh call received overwrites the
first.
When a call has been stored by the radio, an alert
will sound, the call in absence icon will flash
and will remain flashing until the stack is empty.
To view the calls in the stack, press the call in
absence button (12). The call in absence
display will look like this:
where ‘01’ indicates the position in the stack and
‘1234567’ is the number of the calling party.
Use Up/Down buttons (8) to scroll through entries
in the stack. Select an entry by pressing the Select
button (10). The display will change to the
general display and the entry is deleted from the
stack.
Pressing the defined call button will automatically ‘call
back’ to this number.
To exit the Call in Absence stack at any time, press
the Clear button (9) for longer than 2 seconds.
If the Scan function is programmed into your radio,
entry into the Call in Absence stack will stop scan.
After calling back an entry in the stack or exiting the
Call in Absence stack edit mode, you should re-
start scan.
Note:
The calls in the stack are not deleted when the
radio is turned off.
1 2 3 4 5 6 7
–
0
1
Communication Procedures/Call in Absence
GM950 User Guide [EN] Page 6 Wednesday, December 3, 1997 2:18 pm
To Next Page
Loading...
