Test Equipment 3-17
11.0 Test Equipment
Table 3-2 lists test equipment required to service the GP100 Series Radios and other two-way radios.
Table 3-2 Recommended Test Equipment
Motorola
Part No.
Description Characteristics Application
R2600CNT Comms System
Analyzer (non
MPT)
This monitor will
substitute for items with
an asterisk *
Frequency/deviation meter
and signal generator for wide-
range troubleshooting and
alignment
R2600ANT Comms System
Analyzer
(MPT1327) to be
ordered with
RLN1022A (H/W)
RLN1023A (S/W)
This monitor will
substitute for items with
an asterisk *
Frequency/deviation meter
and signal generator for wide-
range troubleshooting and
alignment
*R1072 Digital Multimeter Two meters recommended for
AC/DC voltage and current
measurements
*S1053,
*SKN6009,
*SKN6001
AC Voltmeter,
Power Cable for
meter, Test leads
for meter
1 mV to 300 V,
10 Megohm input
impedance
Audio voltage
measurements
R1094 Delay
Oscilloscope
20 MHz bandwidth,
5 mV/cm - 20 V/cm
Waveform measurements
*S1350,
*ST1215 (VHF)
*ST1223 (UHF)
*T1013
Wattmeter,
Plug-in Elements
(VHF & UHF), RF
Dummy Load
50-Ohm, ±5% accuracy
10 W, max. 0-1000
MHz, 300 W
Transmitter power output
measurements
S1339 RF Millivolt Meter 100 mV to 3 VRF,
10 kHz to 1.2 GHz
RF level measurements
To Next Page
Loading...
