Chapter 5
RADIO TUNING AND PROGRAMMING
1.0 Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and tuner program
which are designed for use in a Windows 95/98 environment. These programs are available in
separate kits as listed in the Table 5-1. An Installation instruction manual is also included with each kit.
Table 5-1 Software Installation Kits Radio Tuning Setup
2.0 Global Radio Tuning Setup
A personal computer (PC) using Windows 95/98 and a global tuner program are required to tune the
radio. To perform the tuning procedures, the radio must be connected to the PC, radio interface box
(RIB), and test equipment shown in Figure 5-1.
Figure 5-1 Radio Tuning Test Equipment Setup
NOTE
Refer to the appropriate program on-line help Þles for the programming procedures.
Description Kit Number
EMEA CPS Diskettes ENLN4004
Global Tuner Disk ENLN4014
Installation Manual 68P64113B12
Wattmeter
Audio Generator
Sinad Meter
AC Voltmeter
30 dB Pad
30 dB Pad
Battery
Block
Power
Supply
Audio In
Tx
Rx
Receive
Transmit
RF Generator
BNC
RF Adaptor
HLN9756
RIB
RLN4008
RIB Power Supply
RLN4460
Test Box
Rx
Gnd
Data
Tx Data
Radio
Computer Interface
Cable 3080369B72
Program/
RKN 4074
Test Cable
Service Monitor
or Counter
DB15 DB9
AC Plug
120/230 Vac
3.5 mm to
Ferrule BNC
Double Male
RLN4510
+12VDC
0180305G54
Battery
Eliminator
7.5V Reg.
To Next Page
Loading...
