29
TRUNKED FEATURES
English
If the page is unsuccessful
If the page is successful
PROGRAMMING THE RADIO’S LISTS
(GP280 RADIOS ONLY)
Programming the
Telephone List Numbers
This feature lets you use the radio’s keypad to change
the telephone numbers assigned to any of the
telephone list members. Each phone number can
have up to 16 digits.
To change the telephone list
6a. If you hear one beep, the ID number has been
received by the system, but the radio you are
paging is not on the air; your radio remains in
the Call Alert mode.
If after six seconds the called radio fails to
acknowledge the alert, a low-pitched alert
tone sounds and the display changes to “NO
ACKNOWLEDGE”.
6b. Press the PTT switch to send the ID number
again, or press . to hang up and return to
the home display.
6a. If you hear five beeps, the ID number has
been received by the system, and the radio
you are paging is on the air and has received
your page.
6b. The radio automatically
returns to the home dis-
play
PLANT POLICE
1. Press / until PROG
is displayed.
2. Press l (the softkey
below PROG).
3. Press ; (the softkey
below PHON). The dis-
play shows the first
programmable member
of the telephone list.
4. Press / or ,,
—or—
Use the keypad to enter the desired member’s
position number (1 to 19) to view the members
of the telephone list.
PROG
SCAN
PHON
CALL
FIRE DEPT
UG_240_280_EN.fm Page 29 Wednesday, August 14, 2002 10:30 AM
To Next Page
Loading...
