39
SCAN
English
SCAN
This section outlines the scan functions of your radio.
All references to what is shown on the display is only
valid forGP280 radios. Throughout this section, the
display below
is used to indicate the radio’s home display.
SCAN OPERATION
The scan feature allows you to monitor activity on
different conventional or trunked modes by scanning a
scan list of modes. This list can be programmed with
the Customer Programming Software (CPS) or user
programmable.
The table below lists the types of scan operations
available depending on radio model.
Automatic scanning (autoscan) can be programmed
through the CPS. If autoscan is enabled for a mode,
your radio begins scanning, using the mode’s scan list,
whenever you select that mode.
The radio will continue autoscanning until you select a
mode that does not have autoscan enabled.
Turning Scan On or OFF with the Keypad
(GP280 radios only)
Note: The scan status annunciator, G, is
displayed when the scan operation is active. It
will be removed from the display when the scan
operation is terminated.
Conventional Comprises conventional-only modes.
Talkgroup
Scan
Comprises conventional modes and
trunked modes from more than one
trunking system.
PLANT POLICE
1. Press / until
SCAN is displayed.
2. Press ; (the soft-
key below SCAN).
You will see the
current scan state
momentarily.
or
Then
3. Press the softkey
below the desired
scan state (on or off).
The radio returns to
the home display.
PHON
SCAN CALL
SCAN ON
SCAN OFF
ON
OFF
PLANT POLICE
UG_240_280_EN.fm Page 39 Wednesday, August 14, 2002 10:30 AM
To Next Page
Loading...
