To Next PageTo Next Page
Need help?Do you have a question about the Motorola H710 and is the answer not in the manual?
General| Type | Bluetooth Headset |
|---|---|
| Talk Time | 6 hours |
| Standby Time | 200 hours |
| Charging Time | 2 hours |
| Wireless Range | Up to 33 feet (10 meters) |
| Noise Cancellation | Yes |
| Compatibility | Bluetooth-enabled devices |
Charge your headset's battery for 2 hours. The indicator light turns red while charging and green when fully charged.
Open the headset boom to power on and initiate pairing. Indicator light becomes steadily blue.
On your Motorola phone, navigate to Bluetooth Link > Handsfree > Look for Devices and select your headset.
Make a call to confirm your paired phone and headset are operating properly. Close boom to turn off.
Turn off other paired devices, then turn off headset. Repeat pairing steps for the second phone.
Turn on the first phone, then use it to connect to the headset to re-establish connection to both phones.
Tips for handling incoming calls, last number redial, and voice dial access from multiple connected phones.
Ensure other paired devices are off. Turn off and reopen headset boom if indicator light is flashing blue.
Ensure headset indicator light is on and steady blue when phone is searching for devices.
Verify phone is on and Bluetooth is enabled. Restart Bluetooth feature and re-pair if necessary.
Press and hold Volume and Call buttons for 10 seconds to enter pairing mode.
Open the headset boom. The indicator light flashes blue or is steadily lit, indicating status.
Close the headset boom. The indicator light will turn off, conserving power.
Open boom and earhook. Loop earhook over ear, press headset to ear, and point boom towards mouth.
Open boom and earhook, remove earhook from hinge pin, flip headset, and reattach earhook to the other side.
Turn headset off, press and hold desired volume button, then open boom. Keep button pressed until light flashes blue.
Open boom, press and hold Volume buttons to check indicator light for battery charge level and talk time.
Tap the Call button, speak name after tone (primary) or with Volume button (secondary).
Tap the Call button to end the call, hearing a high-to-low tone.
Open boom or tap call button to answer a call, hearing a ring tone.
Press and hold either Volume button until you hear a tone to reject an incoming call.
Press and hold the Call button until you hear a tone to redial the last outgoing call.
Press and hold the Call button to answer, placing the first call on hold.
Press both Volume buttons and Call button to transfer call to phone, hearing a descending tone.
Tap both Volume buttons until you hear a mute tone to mute or unmute the microphone.
List of audio tones and their corresponding headset status, such as incoming call, end call, or low battery.
Details indicator light status (off, flashes, steady, slow pulse, quick flash) and corresponding headset states.
Details indicator light status (red, yellow, green) for battery level and charging status.
